Maintenance Spring Continues

It seems that every time we have come to the boat this spring, something has required attention.  When we arrived this past Saturday, yet another maintenance item reared its head.  When I turned on the power to the fresh water pressure pump, we were greeted with the sound of... nothing.  No water pressure.

A little bit of diagnostics disclosed that the pump was ok, but the pressure switch was not.  

Since it is nearly impossible to remove the pressure switch assembly with the pump installed without dropping important bits into the bilge, it had to come out.  Now that sounds somewhat trivial, but it is not.  Advanced Class IV boat yoga is required to get a screwdriver on the mounting screws, and the water connections are even worse.

Once removed, I disassembled the pump head and pressure switch assembly.  Delving into the switch assembly, I discovered that the micro switch which actually controls the power feed to the pump had failed mechanically.

The micro switch, shown with a thumbdrive for scale

Since we had a spare pump head aboard, I "simply" installed it and reinstalled the pump, thinking that I'd look at getting another micro switch and repairing the old pump head to keep as a spare.

Ha!

The brand new pump head would not move water.  I presume this was due to the internal flapper valves having taken a set.  It took me 3 more install/removals of the pump to confirm that the new head was not going to work.  I really dislike when new stuff fails to work out of the box.

So for the fourth time I removed the pump, and reinstalled the old pump head but with the pressure switch from the new head.

It worked.  But the pump shuts off almost immediately, telling me that I reassembled the pressure switch incorrectly (I think I know what's wrong).  

So, I took an Ibuprofin and ordered a couple new micro switches via Amazon.  I will rebuild the old pressure switch next weekend. And then I will have to employ the advanced boat yoga one more time (hopefully...) to reinstall the rebuilt pressure switch assembly.  

Then all I will have remaining is to recalibrate the pressure switch so that the pump delivers the desired pressure.  That will only require Class III boat yoga.

Hopefully.

Maintenance Spring Continues

Valves, Oh My!

Eolian's two valves which select which water tank the domestic supply is drawn from have been getting more and more difficult to turn over the years.  This spring, I decided that enough was enough...  before I broke something.  They were bronze valves, and were as old as the boat.

Here's the plumbing tree.  Water supply from the two tanks is at the top left and right.  Feed to the pressure pump is from the strainer at the very bottom.  The small pipe leading off to the left is the supply from the water maker, and the capped off grey pipe is the supply to the fresh water foot pump in the galley sink.

Before

 

 

So, in a fit of activity, I disassembled the valve tree and replaced the old valves with PVC/Teflon ball valves - they are only a little longer than the old ones and there is plenty of room for them.  Also, they open and close like a dream because the seats are Teflon.

And while I was at it, I added a valve in the galley foot pump supply and reconnected it.  (I capped this off back in 1997 because the foot pump flapper valves slowly leaked air back into the system, making the freshwater supply pump constantly cavitate.)  Now we can have the use of the foot pump by simply opening a valve.

After

 

 

Finally as a side note, I do not leave both tanks connected together because by keeping them separate, in the event of a leak the worst case scenario is that I would only lose half of my fresh water.  (I keep both diesel tanks separate for the same reason.)

Valves, Oh My!